Mobotix MX-NPA-POE-INT-SET Especificaciones descargar pdf (Pagina 4)

Connection Option 2

MOBOTIX AG • 67722 Langmeil, Germany • Tel.: +49-6302-9816-103 • Fax: +49-6302-9816-190 • [email protected]

Power Supply With Integration Of A Switch/Router

1. Connect the camera's Ethernet patch cable, or that of the PoE device that is to be supplied, to the "Camera"

connector of the blue adapter.

2. Connect the "LAN/Power" connector of the adapter to the Ethernet connector of the switch/router or the

Ethernet socket.

3. Plug the RJ45 connector of the power supply unit/battery into the "PC/Power" connector of the adapter.

Please see the note "Connection Cable To The Battery."

Status LED On The Adapter (Primarily For Battery Operation)

An LED light, which indicates the status of the adapter's power supply based on their color, is located on

the upper side of the blue adapter. This is especially important during battery operation. The LED is green

when the input voltage is 16volts or higher. This indicates a maximum PoE output rating of 12.95watts (all

PoE classes and devices). If the LED is orange, only class 1 and 2 PoE devices can be supplied (a max. of

6.49watts; for example, a MOBOTIX camera with and without USB devices). A red status LED indicates low

voltage, for example, the battery is almost empty. The device is permanently disabled for total discharge

protection of the battery at less than 10volts.

Voltage (Input) PoE Output LED

> 16V Classes 1 to 3 (up to 12.95W) Green

12V–16V Classes 1 and 2 (up to 6.49W) Orange

10V–12V Lower than class 1 (< 3.84W) Red

< 10V No power supply O

Switch/router

Adapter

Power supply (or battery)

LAN/WWW

PC Camera/PoE device

LAN/Power

PC/Power

Camera

RJ45

1 2 3 4 5 6 7 8

Sin comentarios

Mobotix MX-NPA-POE-INT-SET Especificaciones Pagina 4