Mobotix T24S Información técnica descargar pdf (Pagina 86)

86/98

T24 System Manual Part 2: System Restore

www.mobotix.com • [email protected]

5.2.4 Exchanging Mx2wire Components

The T24’s Mx2wire set always consists of two devices: the

outdoor station’s info module featuring Mx2wire technology,

and a second indoor unit installed inside the building.

When you exchange them, the door station’s power supply is

disconnected automatically. The door station is automatically

ready for operation again once the power supply has been

reconnected. A system restore is not required.

Proceed As Follows:

1. Disconnect the door station and Mx2wire components

from the power supply.

2. Remove the Mx2wire info module to be exchanged

from the module frame as described in the T24 System

Manual Part 1/Section 2.4.6 (Removing And Exchanging Modules).

3. Exchange the old info module and indoor unit with the new devices. Take care not

to damage the cabling or mix up the connections. The connection diagrams are

provided in the T24 System Manual Part 1.

4. Power up the system again. After an automatic reboot, the door station is ready

for operation again.

Notes

The two Mx2wire units are matching pairs and preconﬁgured at the factory. Matched

units share the same network ID (see labels on the back of the info module and on the

indoor unit’s circuit board). In case of a defect, both units must always be exchanged

for a new Mx2wire pair that has been conﬁgured by MOBOTIX and shipped in its

original packaging.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 99 100

Sin comentarios

Mobotix T24S Información técnica Pagina 86