Mobotix D15Di-Sec-180 5MP Especificaciones descargar pdf (Pagina 57)

57/124

First Installation Steps

www.mobotix.com • [email protected]

10.

Secure the cable

: Properly lead the cable through

the cable guides at the outer rim of the housing

and make sure that the outer shell can be properly

mounted later on.

11.

Attach the outer shell

: Hold the outer shell so that

the round hole of the shell is positioned over the PIR

sensor of the camera. Gently press the shell into the

shell’s seats in the camera housing. Old outer shells

(D10D, D12D) may no longer be used!

2.3.5 Connecting MxBus Modules

The MxBus connection of the camera is located under the

cable cover and enables additional modules to be operated

to extend the functions of the camera. MxBus was optimized

speciﬁcally for the use of existing two-wire cables.

The white (detachable) MxBus connector has four connec

tions (each of which is blue/red or +/-):

•

2 MxBus inputs to connect the D15D to the MxBus cable

• 2 MxBus outputs to connect an MxBus module to the D15D

Notes

The MxBus wires that are to be stripped at the end should ideally be inserted into

the camera before installation. In the process, every wire

(coming from the housing ﬂoor) should be pushed through

an elastic sealing membrane.

Do not mix up the polarity of the cables during installa

tion. Select a consistent cable color for +/- in the entire

MxBus system (for example, red = +, blue = -).

After an MxBus module has been connected, the MxBus itself must be started in

the camera's web-based user interface (if this has not been done yet) as well as the

actual module (Admin Menu> Manage Hardware Expansions or MxBus Modules).

You are free to choose

the position of the

cable for the MxBus

connector’s inputs and

outputs (left or right)

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 123 124

Sin comentarios

Mobotix D15Di-Sec-180 5MP Especificaciones Pagina 57