Mobotix D12 Información técnica descargar pdf (Pagina 58)

(4) Attaching the dome

Take a cotton cloth and attach the dome to the camera by turning it in a

clockwise direction. This will prevent you

from accidentally repositioning the lenses

during the rest of the installation process.

Important: Position the mark on the dome

pointing towards the camera's PIR sensor and

gently seat the dome into the threads. This

will prevent misaligning the threads of the

dome!

Note: The camera comes with an additional

tinted dome with reduced transparency (25%)!

(5) Attaching the Ethernet and ISDN cables

Lead the CAT5 cables through the appropriate holes in the casing. Make

sure that the cables are running properly as shown in the figures below.

Properly lead the cable through the cable guides at the outer rim of the

casing. Follow the same steps and position any other cables (ISDN, RS232)

just like the Ethernet cable. If you are only using one cable, close the unused

cable guide with one of the supplied rubber plugs. This will ensure that the

camera remains weatherproof (IP65*), even if it has only one cable (see

bottom right figure).

*Only Outdoor models

www.mobotix.com • [email protected] • 23.11.2006

56/96

D12 Camera Manual Part 1

Tighten the dome by

turning clockwise

Align the mark of the

dome with the PIR sensor

Lead the cables through

the cable guides at the

outer rim of the casing

If only one cable is used,

close the unused cable

guide with the supplied

rubber plug

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 99 100

Sin comentarios

Mobotix D12 Información técnica Pagina 58