Mobotix MX-D25M-SEC-D76 Especificaciones descargar pdf (Pagina 112)

112/140

D25M Camera Manual: Operating the Camera

www.mobotix.com • [email protected]

3.2.5 Starting the Camera with the Factory IP Address

If your network has a DHCP server, you can start the MOBOTIX camera with DHCP support.

The camera automatically obtains an IP address from the DHCP server and announces the

new network data. Please note that this announcement can only be heard if the camera

is connected to an external speaker.

1. If the camera is powered on, disconnect the power supply by unplugging the cor

responding cables and then reconnect the power supply.

2. Wait until both LEDs light up simultaneously for the ﬁrst time.

3. Press the L key within the next four seconds and hold it down (if you need to

try again, go back to Step 1). Use a suitable device to press a key (a ball-point pen,

for example).

4. After about 30 to 45 seconds, the camera emits a single sound (“boing”).

The camera has ﬁnished booting and can now be used (e.g., MxEasy, MxControlCenter,

MOBOTIX App, web browser).

Notes

If you use the camera’s L key to load the factory network conﬁguration, this conﬁgu-

ration is not automatically saved in the camera’s ﬂash memory. When the camera

is next rebooted without using the L key, the last stored network conﬁguration will

be used. To permanently store the new network conﬁguration in the camera’s ﬂash

memory, open Admin Menu> Store.

As opposed to resetting the camera using Admin Menu> Reset conﬁguration to

factory defaults, the user information will not be reset if the camera is booted using

the factory IP address.

Passwords and cam-

era settings will

not be changed

Make sure you store

the default network

conguration to the

permanent ash memory

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 139 140

Sin comentarios

Mobotix MX-D25M-SEC-D76 Especificaciones Pagina 112