Mobotix MX-D25M-SEC-D76 Especificaciones descargar pdf (Pagina 92)

92/140

D25M Camera Manual: Installation

www.mobotix.com • [email protected]

• Remove the camera dome: Take the delivered plastic foil

or a cotton cloth, insert the dome into its seat and turn it in

clockwise direction.

•

Attach the outer shell: Place the outer shell onto the camera

and tighten all four Allen screws using the supplied Allen

wrench. Make sure that the rubber seal is seated properly.

2.9.7 Connecting a Two-Wire MxBus Cable

You can use such a cable to connect additional MOBOTIX

modules (e.g., the MX-GPS-Box or the MX-232-IO-Box)

to the D25M.

Note that you can attach one MxBus cable (with two

wires) to the MxBus connector (red arrow in ﬁgure). Take

care not to switch the polarity of the wires. It is recom-

mended to use the same wire color for +/– for the entire

MxBus system (e.g., red= +, blue= –).

Procedure

• Uninstall camera: Remove the camera so you can access

the connectors on the back.

•

Remove the outer shell: Remove all four Allen screws using

the supplied Allen wrench. Take o the outer shell.

•

Remove the camera dome. Take the delivered plastic foil or

a cotton cloth and remove the dome by turning it in counter-

clockwise direction.

In order to attach MxBus

modules, you need to

use the supplied MxBus

connector with two-wire

connection line and two

single-wire connectors:

The length of the entire

MxBus wiring must not

exceed 50 m/55 yd!

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 139 140

Sin comentarios

Mobotix MX-D25M-SEC-D76 Especificaciones Pagina 92