Mobotix MX-D25M-SEC-D76 Especificaciones descargar pdf (Pagina 84)

84/140

D25M Camera Manual: Installation

www.mobotix.com • [email protected]

2.7.3 Mounting to a Wall or Building Corner

Use the supplied screw anchors, screws and washers to ax the Corner and Pole Mount

to a building corner.

• Mark the four screw anchor holes on the corner of the

building, ensuring that the arrows on the mount point

upwards. Drill the holes with a 10 mm wall drill.

•

Pass the on-site network cable through one of the large

round holes at the back of the Corner and Pole Mount,

then through one of the 16mm diameter holes on the

front of the mount. In order to properly protect the

cabling, you should let the cabling run from the inside

of the building through the Corner and Pole Mount

directly into the camera (concealed cabling). Note: The

cable length from the building corner should be at

least 80cm!

• Place the included wall anchors in the drilled holes

and screw the Corner and Pole Mount into place on

the corner of the building using the Torx screws and

washers. Use the supplied drilling template (fold-out

at the end of this manual) to mark the exact positions

for the drill holes.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 139 140

Sin comentarios

Mobotix MX-D25M-SEC-D76 Especificaciones Pagina 84