Mobotix MX-D25M-SEC-D76 Especificaciones descargar pdf (Pagina 61)

61/140

Mounting the Camera Without Accessories

www.mobotix.com • [email protected]

4. Remove the internal part of the camera with the lens

mount from the base of the camera.

5. Position the base of the camera housing over the

drilled holes and the prepared cable exit. Please make

sure that the camera base is relatively ﬂush with the sur-

face. The network cable with connector should be ﬂush

with the ceiling or wall as a result. Since the three holes

for the screws in the outer shell are factory sealed, they

must broken open, for example, using a 5mm drill bit.

6. Tighten the base of the camera using the supplied

screws. Depending on the installation site, the screw

openings should be sealed shut (e.g. with silicon).

7. Insert the internal part of the camera with the lens

mount into the attached outer shell and secure it by

turning the two blue clamps in a clockwise direction using

the supplied hook wrench or a screwdriver. This will pre-

vent the internal part of the camera from falling out before

it has been tightened into place.

8. Now secure the internal part of the camera by turning

the toothed ring in a clockwise direction until you can still

turn the internal part of the camera without much force.

9. Connect the network cable to the network connector

of the camera.

10.

Proceed to

Section 3.3.1, «Aiming and Adjusting the Lens»

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 139 140

Sin comentarios

Mobotix MX-D25M-SEC-D76 Especificaciones Pagina 61