Mobotix MX-D25M-SEC-D76 Especificaciones descargar pdf (Pagina 71)

71/140

Mounting the Camera with the In-Ceiling Set

www.mobotix.com • [email protected]

Insert the camera and the In-Ceiling Set into the hole: Make sure that all winged

cams are retracted before placing the In-Ceiling Set with the camera into the hole.

Tightening the screws of the In-Ceiling Set extends the winged cams, thus ﬁrmly

holding the set in place.

Install the decorative ring: Use the two wrenches from

the In-Ceiling Set to place the ring on the set as shown

in the ﬁgure and turn the ring clockwise until it stops.

The two wrenches from the In-Ceiling Set are also used

for dismounting. Insert them as shown and turn the ring

counter-clockwise. Loosen the screws of the In-Ceiling

Set; this will automatically retract the winged cams. You

can now remove the In-Ceiling Set, with the camera still

attached, from the ceiling.

9. Proceed to

Section 3.3.1, «Aiming and Adjusting the Lens»

The blue winged cams

(see left) automatically

secure the In-Ceiling

Set in the ceiling when

tightening the screws

Removing the decora-

tive ring:

turn counter-clockwise

– only relevant when

completely remov-

ing the camera

Installing the decora-

tive ring:

turn clockwise

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 139 140

Sin comentarios

Mobotix MX-D25M-SEC-D76 Especificaciones Pagina 71