Mobotix MX-D25M-SEC-D76 Especificaciones descargar pdf (Pagina 58)

58/140

D25M Camera Manual: Installation

www.mobotix.com • [email protected]

2.2.2 Procedure for All D25M Cameras

Install the camera using the following procedure:

1. Install and prepare the network connection.

2. Drill the holes: Please use the enclosed screws and screw anchors whenever

possible. It is essential that you use the supplied drilling template to ensure the

precise alignment of holes for either the mounting ring of the D25M IT/Secure or

the camera base of the D25M Basic (fold-out at the end of this manual).

3. Hollow out background surface for the cable and connector or insert the cable

behind the suspended ceiling or cable duct.

4. Connect the pre-installed network cable of the camera to the installation cable

(adapter not included in delivery).

5. Attach the camera to the ceiling or wall (see sections below).

6. Aim and adjust the lens (see

Section 3.3.1

Caution

For safety reasons, only use the pre-installed MOBOTIX network cable that was

included in the delivery. Always ensure that the rubber plug of the network cable

reliably protects the outer shell from moisture entering the camera. All openings of

the camera housing need to be properly sealed. This is the only way to guarantee

that the camera remains weatherproof.

Notes

Network Connection Without Pre-Installed Cable

The network cable is fed through the ceiling directly above the camera. Make sure

the cable is completely sealed by the rubber gasket on the housing (do not bend the

cable!) When preparing the installation, ensure that at least 15cm of cable length

(excluding the connector itself) remains inside the camera housing (similar to factory

preinstallation). This will ensure that you can turn and tilt the lens mount freely later on.

Surface-Mounted Socket

If a surface-mounted socket is used, the camera must be mounted using the out

door Wall Mount. The camera cannot be mounted directly on top of protruding,

surface-mounted sockets.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 139 140

Sin comentarios

Mobotix MX-D25M-SEC-D76 Especificaciones Pagina 58