Mobotix MX-KEYPAD1-EXT-SV Información técnica descargar pdf (Pagina 120)

120/148

T24 System Manual Part 1: Installation

www.mobotix.com • [email protected]

2.8 Finishing The Installation

2.8.1 Checking The Wiring And Activating The Anti-Theft Protection

After installing and connecting the door station, you will need to test the power supply to

the individual modules and the T24-DoorMaster.

Connect all the installed components (T24 outdoor station, T24-DoorMaster, door opener/

Mediator, door sensors, light and so on) and connect the power supply (switch on PoE

switch/router and all power supply units used). The MOBOTIX IP Video Door Station starts

up after the power supply is connected. The entire system starts up.

The buttons on the T24-CamCore light up for four seconds. Without pressing a button,

wait until the lights go out after a few minutes and then light up again.

Notes

The blinking of the green LED on the keypad and T24-DoorMaster indicates that data is

communicated between the individual modules via Mx-Bus but the data communication

is still unencrypted. After the system is started up (see Part 2 of the System Manual), the

green LED lights up continuously (MxBus data communication is encrypted).

The LED on the keypad lights up red when the communication of data via MxBus is

interrupted (for example, if the camera module stops working).

T24-KeypadRFID LEDs

ﬂash green and blue

T24-CamCore keys

light up

T24-DoorMaster LEDs

ﬂash green and blue

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 149 150

Sin comentarios

Mobotix MX-KEYPAD1-EXT-SV Información técnica Pagina 120