88/148
T24 System Manual Part 1: Installation
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
2.4.3 Installing The Info Module T24-Info
The info field in the info module of the T24 door station without Mx2wire+ technology is
equipped with permanent LED backlighting supplied via MxBus.
1. Ensure that the seal is fitted to the info module.
2.
Loosen the rear cover plate (using a small screwdriver
or similar tool) and remove it. You now have a clear
view of the connectors located directly on the info
module board.
3.
Remove approximately 5 mm of insulation from each
of the cables to be connected and feed each cable
through one of the wire apertures in the housing
(piercing the rubber membrane with the cable).
Seal
Comentarios a estos manuales