Mobotix MX-KEYPAD1-EXT-SV Información técnica descargar pdf (Pagina 80)

80/148

T24 System Manual Part 1: Installation

www.mobotix.com • [email protected]

2.4 Installing The T24 Modules

Caution

Beware of short circuits: When you install the modules, the MxBus cable should

not be live, which means that the network cable should still be disconnected from

the PoE switch.

2.4.1 Installing The Camera Module T24-CamCore

Standard Network Connection

The Ethernet terminal board is used to connect the door station for the T24 version without

Mx2wire+ technology. It connects the short, pre-installed camera patch cable with the

eight split-out wires of the network installation cable (for installation, see Section 2.2.5).

1. Ensure that the seal is ﬁtted to the camera module.

Connect the supplied MxBus cable to the push terminal

on the rear wall of the camera. Remove approximately

5 mm of insulation from the cable ends and push

into the terminal.

• Red wire to + terminal

• Blue wire to - terminal

Note

To connect the MxBus cable of the T24-DoorMaster, the two free MxBus terminals

of the camera module can be used as an alternative to the MxBus terminals on the

keypad or info module (see Section 2.5).

Seal

C" !"# 2-*> +5$

U *'; ? - #$2

S5$' 32&'@ * ;&(($#$'+?

1"<"#$; 1*/<$A )*6$

23#$ +5$ 1"##$1+

>"<*#&+4 &2 #"3+$;

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 149 150

Sin comentarios

Mobotix MX-KEYPAD1-EXT-SV Información técnica Pagina 80