Mobotix MX-KEYPAD1-EXT-SV Información técnica Pagina 84

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 150
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 83
84/148
T24 System Manual Part 1: Installation
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [email protected]
2.4.2 Installing The T24-KeypadRFID
Please pay attention to the dierent system wiring configurations that apply (described in
Section 2.1), depending on whether or not the T24-DoorMaster and external devices such
as a light are used.
1. Ensure that the seal is fitted to the keypad.
2.
Loosen the rear cover plate (using a small screwdriver
or similar tool) and remove it. You now have a clear
view of the connectors located directly on the keypad
board.
3.
Remove approximately 5 mm of insulation from each
of the cables to be connected and feed each cable
through one of the wire apertures in the housing
(piercing the rubber membrane).
Seal
Vista de pagina 83
1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 149 150

Comentarios a estos manuales

Sin comentarios