Mobotix MX-KEYPAD1-EXT-SV Información técnica descargar pdf (Pagina 74)

74/148

T24 System Manual Part 1: Installation

www.mobotix.com • [email protected]

2.3.5 Mounting The Terminal Board And Fitting The Network Cable

Mounting The Ethernet Terminal Board

Screw the board into the housing (ﬂattened side is at the bottom). The terminal board

must be placed behind the camera module. This step is not necessary for the T24 version

with Mx2wire+ technology (two-wire cable replaces Ethernet cable), as an Ethernet terminal

board is not required.

Stripping And Fitting The Network Cable

The Ethernet terminal board provides a link from the network installation cable to the

special patch cable of the camera module mounted directly above.

Connect the eight wires of the installation cable (with stripped ends) to the corresponding

contacts on the terminal board in accordance with the sticker (ﬁg. standardized color coding

according to TIA-568B). Fasten the network cable so that its shielding rests on the terminal

board contact ﬁeld (using the enclosed cable tie).

="# 1"''$1+&'@ $0+$#'*<

;$7 1$2A *' $0>*';$;

+$#) '*< /"*#; P89:?

M[8?KMQ 1*' /$

)"3'+$; ' ><*1$ "( +5$

`+5$#'$+ +$#)&'*< /"*#;

P2$$ D$1+&"' 9.X.9Q

Attachment of board for vertical

and horizontal installation

\5$16 -5$+5$# +5$

'$+-"#6 1*/<$ *+

["` 2-&+15Q &2 -&#$;

*11"#; '@ +" cJFa "#

cJFN P2$$ 2+ 16$#Q

="<<"- +5$2$

)$*23#$)$'+2 -5$'

2+# >> '@ +5$ 1*/<$

Z 9c ))

EG ))

Network cable retainer

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 149 150

Sin comentarios

Mobotix MX-KEYPAD1-EXT-SV Información técnica Pagina 74