Mobotix MX-KEYPAD1-EXT-SV Información técnica descargar pdf (Pagina 90)

90/148

T24 System Manual Part 1: Installation

www.mobotix.com • [email protected]

2.4.4 Installing The Info Module T24-Info2wire+

The info module with integrated Mx2wire+ technology is used to connect the door station

to the network via a two-wire cable such as a bell wire and has an info ﬁeld with permanent

LED backlighting.

1. Ensure that the seal is ﬁtted to the info module.

Loosen the rear cover plate (using a small screwdriver

or similar tool) and remove it. You now have a clear

view of the connectors located directly on the info

module board.

Remove approximately 5 mm of insulation from each

of the cables to be connected and feed each cable

through one of the

wire apertures

in the housing

(piercing the rubber membrane with the cable).

Connect the two-wire cable, which leads to the separate

T24-Info2wire+ unit in the building, to the board.

• First wire to Data 1 terminal

• Second wire to Data 2 terminal

Seal

89:?K'("9-&#$U ';""#

3'&+ P("# '2+*<<*+&"'A

2$$ D$1+&"' 9.JQ

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 149 150

Sin comentarios

Mobotix MX-KEYPAD1-EXT-SV Información técnica Pagina 90