Mobotix MX-KEYPAD1-EXT-SV Información técnica descargar pdf (Pagina 71)

71/148

Mounting The Frame And Housing

www.mobotix.com • [email protected]

In-Wall (Fig. Triple Housing)

Connect the housing with the subsurface so that the bars ﬁtted

to the edge are still visible. The required opening should be

116 x 318 mm. Turn the housing over and use it as a template

to mark the holes.

Dimensions for installation opening (W x H x D):

• Single housing: 117 x 129 x at least 52 mm

• Double housing: 117 x 218 x at least 52 mm

• Triple housing: 117 x 318 x at least 52 mm

Caution

Make sure to install the in-wall housing carefully using the inserted protective

cardboard so that it is not deformed by any pressure from the surrounding material.

Otherwise the frame may not be installed properly and may not be sealed against

the weather.

To prevent cement or plaster from soiling the inside of the

housing, insert the supplied protective cardboard again

before installing the housing in the subsurface of the wall.

After you have secured the in-wall housing, you can easily

remove the protective cardboard by pushing through the

pre-punched opening and simply pulling out the cardboard.

117 mm

318 mm

B&'+, 83#' +5$

'?-*<< 2"16$+ "7$# *';

32$ &+ *2 * +$)><*+$

+" )*#6 +5$ 5"<$

d$*; '@ $;@$ "( 5"32&'@

W325 -&+5 -*<<

Pierce opening hole

and pull through cardboard

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 149 150

Sin comentarios

Mobotix MX-KEYPAD1-EXT-SV Información técnica Pagina 71